Oil and gas field · Neuquén Basin

Loma Campana field

The first unconventional producing cluster outside North America, developing the Vaca Muerta Formation 90 km north-west of Neuquén city. It covers 395 square kilometres in the north of the historic Loma La Lata area.

Last updated · Atlas version 0.29.0

In the Neuquén Embayment, 90 km north-west of the city of Neuquén and 5 km from Añelo, bounded to the south by the Neuquén River.

Overview

Field record

Discovered
2010 (shale oil in well LLL-479, shale gas in LLLK.x-1)
Location
Neuquén Province, Argentina, 5 km from Añelo
Wells
More than 480 producing (78% vertical or directional, 22% horizontal)

Revista de la Asociación Geológica Argentina 75 (2)[1]

Area

395 square kilometres[1]

Vaca Muerta thickness

80 m in the east to 320 m in the west, using a 1% organic carbon cut-off[1]

Rock properties

Average 3% organic carbon and 9% porosity (4 to 15%); water saturation from 25% in the east to 55% in the west[1]

Minerals

46% carbonate, 33% siliciclastic, 18% clay and 3% pyrite; the clay is mostly illite and mixed illite and smectite[1]

Entry coverage

11 of 13 topics

Not yet sourced

First production, Seal. These are added only when a public source supports them. How the Atlas is made

The story

  • Shale oil and shale gas were found in 2010 in wells LLL-479 and LLLK.x-1 in Loma La Lata Norte, followed by delineation and a pilot development.[1]
  • In 2013 YPF and Chevron formed a joint venture for the block, and drilling reached 22 rigs. The pilot covered 100 wells in a 5,000-acre tract of a 96,000-acre concession.[1, 2]
  • Development moved to factory mode, with 4 to 8 wells drilled from each pad and completed together. It became the first operational laboratory for developing the Vaca Muerta that way.[1, 3]
  • Early drilling with vertical wells focused on a sweet spot in the north-west. From 2015 the effort moved to horizontal wells in the east, aimed at the two richest levels.[1]

Geology

Geological setting

Published interpretation

A gently dipping homocline toward the north-north-east. The eastern part has little deformation and few regional faults; the central and western parts have a set of en echelon faults striking north-west, reactivating older basement extension.[1]

The trap

Published interpretation

A continuous accumulation: oil and gas are produced from the Vaca Muerta source rock itself.[1]

Reservoir rocks

Reported
  • Vaca Muerta Formation

    Late Jurassic to Early Cretaceous marls and organic-rich mudstones of the Neuquén Basin, the main proven source rock of the basin and, since 2010, its leading shale oil and gas reservoir.

Source rock

Reported

The Vaca Muerta itself, which is both source and reservoir.[1]

What a well drills through

The main rock layers above and in the reservoir, top down. Tap a layer for a summary.

  • Limestone and marl
  • Mudstone and shale
  • Organic-rich mudstone (source rock)
  • Tuff (volcanic ash)
Layers shown in order, not to scale. The reservoir is highlighted. Rock patterns follow the USGS FGDC lithology standard.

Drilling

Where wells do best

Published interpretation
  • Two aggrading cycles over the wind-blown Catriel sandstone hold the best rock: the Cocina at the base, 30 to 40 m of mudstone with 6 to 8% organic carbon and 12% porosity, and the Orgánico above, about 23 m of calcareous mudstone with 10% porosity, where most horizontal wells have landed.[1]
  • Above them six progradations building to the north-west hold further potential. Wells avoid their topsets, which have under 1% organic carbon.[1]
  • The early north-west sweet spot had better rock in the upper Vaca Muerta and more natural fractures, borne out by high production.[1]

What to watch for

Published interpretation
  • The overpressured, naturally fractured Quintuco Formation above was the main drilling problem: it drove costs up and in some cases lost the hole. Underbalanced drilling and casing drilling made the sector workable.[1]
  • Maximum horizontal stress runs between 90 and 110 degrees.[1]

GeoEngine Field Intelligence

This page, inside your geosteering project

Field Intelligence in GeoEngine writes a cited report on the field your well is in: the formations, how they read on logs, where wells do best and what can go wrong. Next, those reports will start from the Atlas entry for your field.

See Field Intelligence

Cite this page

The Atlas changes as sources are added, so give the version and the date you read it. For the facts themselves, cite the original sources listed below.

GeoMaster Atlas (2026). Loma Campana field. GeoMaster Atlas, version 0.29.0, last updated 21 November 2026. Greenstone Energy Ltd. https://geomaster.uk/atlas/fields/loma-campana/.

BibTeX
@misc{geomasteratlas_loma_campana,
  author = {{GeoMaster Atlas}},
  title = {Loma Campana field},
  year = {2026},
  howpublished = {GeoMaster Atlas, version 0.29.0},
  publisher = {Greenstone Energy Ltd},
  url = {https://geomaster.uk/atlas/fields/loma-campana/},
  note = {Last updated 2026-11-21}
}
RIS
TY  - ELEC
AU  - GeoMaster Atlas
TI  - Loma Campana field
PY  - 2026
DA  - 2026/11/21
PB  - Greenstone Energy Ltd
ET  - 0.29.0
UR  - https://geomaster.uk/atlas/fields/loma-campana/
ER  - 

Free to reuse under CC BY 4.0, also commercially, with credit to “GeoMaster Atlas, geomaster.uk/atlas”. The GeoMaster name and logo are not licensed. To cite the whole Atlas, use its DOI: 10.5281/zenodo.24419596.

This page as data:MarkdownJSONthe whole Atlas (data.json)