Oil field · Western Canada Sedimentary Basin
Pembina field
The supergiant Cardium oil field: sandstone and conglomerate in a Late Cretaceous shoreline wedge, waterflooded over 700,000 acres and now drilled again with fractured horizontal wells.
West-central Alberta, about 100 km south-west of Edmonton.
Field record
- Discovered
- 1953
- Discovery well
- Pembina No. 1
- Location
- About 100 km south-west of Edmonton, Alberta
Government of Alberta, Alberta Culture[1]
Area
283,000 ha (700,000 acres), about 4,400 wells by 1980[2]
Remaining reserves in 1975
921 million barrels[3]
New horizontal wells in 2011
About 454 multi-stage fractured wells[4]
The story
- Pembina No. 1 struck oil in 1953. Its oil was produced with a then-new technique: fracturing the sandstone.[1, 5]
- Most of the undersaturated pool went under waterflood; by area it was described in 1975 as the world's largest waterflood project.[2, 3]
- Horizontal drilling took off after the Bonterra Nexstar well in 2008, aimed at thinner, lower-quality Cardium sands.[6]
What a well drills through
The main rock layers above and in the reservoir, top down. Tap a layer for a summary.
- Sandstone
- Mudstone and shale
The trap
Stratigraphic: Cardium sandstones and conglomerates, built out east and south-east into the basin, pinch out inside thick black mudstones.[5]
Reservoir rocks
- Cardium Formation
A Late Cretaceous wedge of mud, sand and pebbles laid down in the inland sea that crossed North America. Its sandstones and conglomerates hold the supergiant Pembina field.
Where wells do best
- Closer fracture spacing and longer laterals improve horizontal wells most; well direction matters little. A 6% density-porosity net-pay cut-off only predicts the best wells once completions are taken into account.[6]
- The eastern part of the field has poorer rock and production than the central and western parts.[4]
What to watch for
- There are two separate producing sandstone zones, each with its own gas-oil ratio, bubble point and oil properties, so fluid data from one zone does not fit the other.[2]
Open questions
- Discovery year. Alberta's Energy Heritage and the Geological Atlas of the Western Canada Sedimentary Basin give 1953, the year Pembina No. 1 struck oil, and the Atlas uses it. Kerr (1980) gives 1954.[1, 2, 5]
Where sources disagree, the Atlas shows each view with its source. How the Atlas is made
GeoEngine Field Intelligence
This page, inside your geosteering project
Field Intelligence in GeoEngine writes a cited report on the field your well is in: the formations, how they read on logs, where wells do best and what can go wrong. Next, those reports will start from the Atlas entry for your field.
See Field IntelligenceSources
Written in our own words from these sources. Checked 17 November 2026.
- 1Alberta's Energy Heritage, conventional oil timeline: Leduc No. 1 (13 February 1947), Redwater (1948), Pembina No. 1 (1953). Government of Alberta, Alberta Culture.
- 2Kerr (1980), A geological explanation for the variation in fluid properties across the Pembina Cardium field. Journal of Canadian Petroleum Technology 19 (2).
- 3MacKenzie (1975), Petrophysical study of the Cardium sand in the Pembina field. SPE 5541, SPE Fall Meeting.
- 4Klein, Kenealey and Makowecki (2012), Comparison of hydraulic fracture fluids in multi-stage fracture stimulated horizontal wells in the Pembina Cardium Formation. SPE 162916, SPE Hydrocarbon Economics and Evaluation Symposium.
- 5Krause and others (1994), Cretaceous Cardium Formation of the Western Canada Sedimentary Basin. Geological Atlas of the Western Canada Sedimentary Basin, chapter 23 (Mossop and Shetsen, compilers). Canadian Society of Petroleum Geologists and Alberta Research Council, online at the Alberta Geological Survey.
- 6Wiseman and Krause (2014), Comparing geology and well completions to production in the unconventional region of the Cardium Formation, northwest Pembina field. AAPG Bulletin 98 (5), 881 to 892.
- 7FGDC Digital Cartographic Standard for Geologic Map Symbolization (FGDC-STD-013-2006), section 37: lithologic patterns. U.S. Geological Survey Techniques and Methods 11-A2.