Oil field · Permian Basin
Spraberry Trend Area field
The main field of the Spraberry play: oil in thin, fractured siltstone and very fine sandstone of deep-sea fans, along the middle of the Midland Basin. Huge in place, hard to recover.
Central Midland Basin, west Texas.
Field record
- Discovered
- 1952
- Location
- Midland and Glasscock counties, Texas
- Depth to top of reservoir
- 6,785 to 8,000 ft
Bureau of Economic Geology Permian Basin play portfolio (reservoir tables to 2000)[1]
Produced to 2000
About 923 million barrels (Midland and Glasscock reservoirs)[1]
Play oil in place
More than 10 billion barrels (whole Spraberry/Dean play)[1]
Recovery
Under 10% from primary production; under 12% after 40 years of waterflooding[2]
The story
- Discovered in 1952. By 2000 the whole Spraberry/Dean play had produced 1,287 million barrels from 40 reservoirs.[1]
- Primary production by solution-gas drive recovered less than 10% of the oil; decades of waterflooding added little. Pilot studies pointed to stress-sensitive permeability and rock wettability as the controls.[2]
- From the 1980s, vertical wells were completed in both the Spraberry and the Wolfcamp shale below: the "Wolfberry" play. Horizontal wells later moved to the Wolfcamp itself.[3]
What a well drills through
The main rock layers above and in the reservoir, top down. Tap a layer for a summary.
- Sandstone
- Mudstone and shale
- Limestone and marl
- Organic-rich mudstone (source rock)
The trap
Stratigraphic: Spraberry sands thin out against mud along the east margin of the Midland Basin.[1]
Reservoir rocks
- Spraberry Formation
Leonardian (Early Permian) submarine-fan siltstone and very fine sandstone in the middle of the Midland Basin. It holds more than 10 billion barrels of oil in place, but recovers only a small share of it.
Where wells do best
- Most oil comes from upward-coarsening sands 10 to 50 ft thick in the upper and lower Spraberry. Pay is best picked where shale volume is under 15% and effective porosity over 7%.[1]
What to watch for
- Two sets of natural fractures give high first rates that do not last: more than 95% of the oil sits in the tight matrix, and after the fractures drain, recovery depends on water soaking into the rock and pushing oil out.[1]
GeoEngine Field Intelligence
This page, inside your geosteering project
Field Intelligence in GeoEngine writes a cited report on the field your well is in: the formations, how they read on logs, where wells do best and what can go wrong. Next, those reports will start from the Atlas entry for your field.
See Field IntelligenceSources
Written in our own words from these sources. Checked 17 November 2026.
- 1Dutton and others (2004), Play analysis and digital portfolio of major oil reservoirs in the Permian Basin, final report: play descriptions, and reservoir tables with discovery year, county, depth to top and cumulative production to 2000 (Texas Railroad Commission and New Mexico data). Bureau of Economic Geology, The University of Texas at Austin, final report to the U.S. Department of Energy.
- 2Putra and Schechter (1999), Reservoir simulation of waterflood pilot in naturally fractured Spraberry Trend. SPE 54336, SPE Asia Pacific Oil and Gas Conference.
- 3Gaswirth (2017), Assessment of continuous oil resources in the Wolfcamp shale of the Midland Basin, Permian Basin Province, Texas, 2016. U.S. Geological Survey Open-File Report 2017-1013.
- 4FGDC Digital Cartographic Standard for Geologic Map Symbolization (FGDC-STD-013-2006), section 37: lithologic patterns. U.S. Geological Survey Techniques and Methods 11-A2.