Oil field · Williston Basin

Elm Coulee field

A giant Bakken field: oil in a thin, dolomitized middle member, found in 2000 and drilled with long horizontal laterals.

Williston Basin, south of the regional Brockton-Froid fault zone.

Field record

Discovered
2000
Location
Williston Basin; about 450 square miles (1,165 km²)
Depth to top of reservoir
8,500 to 10,500 ft
Wells
More than 600 (2009)

AAPG Bulletin 93 (9), 1127 to 1153[1]

Estimated ultimate recovery

More than 200 million barrels[1]

Middle Bakken porosity

3 to 9%, permeability about 0.04 millidarcies[1]

Initial rates

200 to 1,900 barrels a day per horizontal well[1]

The story

  • Found in 2000, the same year horizontal drilling began there. Single, dual and triple laterals on 640 to 1,280 acre units are fracture-stimulated; vertical wells rarely make 100 barrels a day.[1]
  • Most oil comes from the matrix. The upper Bakken shale probably adds some, estimated at under 20%.[1]

What a well drills through

The main rock layers above and in the reservoir, top down. Tap a layer for a summary.

  • Limestone and marl
  • Mudstone and shale
  • Organic-rich mudstone (source rock)
  • Dolomite
  • Sandstone
  • Salt and evaporites
Layers shown in order, not to scale. The reservoir is highlighted. Rock patterns follow the USGS FGDC lithology standard.

The trap

No classic trap: oil sits in the low-permeability middle Bakken, a dolomitized carbonate shoal between the upper shale and the lower member.[1]

Reservoir rocks

  • Bakken Formation

    A thin Late Devonian to Early Mississippian sandwich: two black, organic-rich shales around a silty dolomite and sandstone middle member. The shales made the oil; horizontal wells in the middle member produce it.

Where wells do best

  • Reservoir quality in the middle Bakken improves upward as clay decreases; vertical pay is 8 to 14 ft.[1]
  • Areas of unusually high recovery sit over an antiform above a basement wrench-fault zone, where fractures are likely enhanced.[2]

What to watch for

  • Slight overpressure: a gradient of 0.53 psi/ft.[1]

GeoEngine Field Intelligence

This page, inside your geosteering project

Field Intelligence in GeoEngine writes a cited report on the field your well is in: the formations, how they read on logs, where wells do best and what can go wrong. Next, those reports will start from the Atlas entry for your field.

See Field Intelligence