Basin · USA and Canada
Williston Basin
A basin in the middle of the continent, spanning Montana, the Dakotas, Saskatchewan and Manitoba. Its best-known oil sits in the thin Bakken and the Three Forks below it, unlocked by horizontal wells and hydraulic fracturing. We cover the U.S. part.
How the basin was built
5 chapters, oldest first. Each one left the rocks that wells meet today.
1 · Late Devonian
Salty tidal flats
Dolomitic shale, siltstone and dolostone of the Three Forks formed in salty seas and on tidal flats, with anhydrite nodules low down.[1]
Read more →2 · Devonian to Mississippian
Black mud, shallow sand, black mud
The sea flooded in and left the lower Bakken shale; a fall in sea level brought the sandy, dolomitic middle member; then the upper shale covered everything. Both shales are rich in organic matter.[1, 2]
Read more →3 · Mississippian
Carbonate seas and salt
The Madison Group followed: tight Lodgepole limestones, then Mission Canyon and Charles carbonates, with salt beds in the upper part.[3, 4]
Read more →4 · Cretaceous to Paleogene
Burial cooks the oil
Deep burial pushed the Bakken shales into the oil window. Belts of high heat flow in western North Dakota and eastern Montana control how mature they are.[5]
Read more →5 · Neogene to today
Uplift, then horizontal wells
Uplift and erosion cooled the basin and stopped oil generation. From 2000, horizontal wells opened the Bakken at Elm Coulee; by 2021 more than 17,500 wells had produced about 4 billion barrels.[1, 2, 5]
Read more →
The rock column
Youngest at the top. Tap any layer for a summary, or open its page. Ages follow the international time chart[6].
- Limestone and marl
- Dolomite
- Salt and evaporites
- Mudstone and shale
- Organic-rich mudstone (source rock)
- Sandstone
Fields
3 fields and plays so far. Play figures from the USGS; field facts from the papers cited on each page[1].
- Bakken and Three ForksOil playThe horizontal-well oil play of the Williston Basin: the thin middle Bakken and the upper Three Forks, charged by two black Bakken shales.
- Elm CouleeOilA giant Bakken field: oil in a thin, dolomitized middle member, found in 2000 and drilled with long horizontal laterals.
- ParshallOilA Bakken field in the eastern Williston Basin with low produced gas-oil ratio and the highest recovery factor of three fields studied, where hot fluids may have helped mature the source.
GeoEngine Field Intelligence
This page, inside your geosteering project
Field Intelligence in GeoEngine writes a cited report on the field your well is in: the formations, how they read on logs, where wells do best and what can go wrong. Next, those reports will start from the Atlas entry for your field.
See Field IntelligenceSources
Written in our own words from these sources. Checked 17 November 2026.
- 1Marra and others (2021), Assessment of undiscovered continuous oil resources in the Bakken and Three Forks Formations of the Williston Basin Province, North Dakota and Montana, 2021. U.S. Geological Survey Fact Sheet 2021-3058.
- 2Sonnenberg and Pramudito (2009), Petroleum geology of the giant Elm Coulee field, Williston Basin. AAPG Bulletin 93 (9), 1127 to 1153.
- 3Gaswirth, Lillis, Pollastro and Anna (2010), Geology and undiscovered oil and gas resources in the Madison Group, Williston Basin, North Dakota and Montana. The Mountain Geologist, via the USGS Publications Warehouse.
- 4Sando (1995), Geologic history of salt beds and related strata in the upper part of the Madison Group (Mississippian), Williston Basin, Montana and North Dakota. U.S. Geological Survey Bulletin 2112.
- 5Gelman (2023), Modeling the maturation history of the stacked petroleum systems of the Williston Basin, USA. Marine and Petroleum Geology 155.
- 6International Chronostratigraphic Chart, version 2024/12. International Commission on Stratigraphy.
- 7FGDC Digital Cartographic Standard for Geologic Map Symbolization (FGDC-STD-013-2006), section 37: lithologic patterns. U.S. Geological Survey Techniques and Methods 11-A2.