Overview
| Age | Turonian to Campanian, 93.9 to 72.2 million years ago[1, 2] |
|---|---|
| Rank | Formation[2] |
| Thickness | 240 to 450 ft (73 to 137 m) around Wattenberg, and 240 to 330 ft (73 to 100 m) in the field itself. Each chalk runs from a wedge edge to 80 ft (24 m); each shale is 20 to 150 ft (6 to 46 m).[2, 3] |
| Where | Over most of the Rocky Mountain region, including the Denver and Piceance basins; its type section is in north-east Nebraska.[4, 5] |
Entry coverage
15 of 20 topics
Not yet sourced
Other names, Type or reference section, Mineralogy, Grain size, sorting and sedimentary structures, Diagenesis. These are added only when a public source supports them. How the Atlas is made
Rocks and composition
How it was laid down
Depositional environment
Published interpretation- Carbonate ramp and shelf. A warm, shallow sea with little sand or mud, where shells, pellets and ooids build limestone and dolomite, deepening to basin muds.[2, 6]
Facies
Published interpretationIts sediment came from the west, so energy fell eastward while organic matter rose: organic carbon is under 1% in the sandier west of the basin and over 7% in the sediment-starved east.[3]
Sequence stratigraphic setting
Published interpretationIts well-known transgressive and regressive cycles are overprinted by bottom currents and later uplifts. From the late Turonian to the early Santonian thick and thin areas swapped through time; from the early Santonian, basement uplifts along the Transcontinental Arch made sediment drape over sea-floor highs.[7]
Boundaries and logs
Boundaries
ReportedErosional unconformities lie at its top and base. Below, the Fort Hays rests on the Codell or lower Carlile; above, the upper unconformity removes the uppermost chalk in parts of Wattenberg and the Pierre Shale follows.[2, 3, 6]
Log response
ReportedThe four chalks are easy to pick on logs from their high resistivity and weak spontaneous-potential deflection.[2]
Dating and diagenesis
Petroleum significance
- Source rock
- Reservoir
Reservoir quality
ReportedPorosity 10% or less and matrix permeability under 0.1 md; a typical Wattenberg value is 14% and 0.05 md. Production comes from four chalk zones 20 to 30 ft thick, so natural and induced fractures are vital.[3]
Source rock potential
ReportedType II kerogen with 2 to 8 weight percent organic carbon. In the Denver Basin it is mature for oil from the Front Range corridor north of Elbert County east to about the eastern edge of Morgan County.[3, 4]
Seal quality
ReportedShaly beds above each chalky or sandy interval seal it.[3]
Members and notes
Smoky Hill Member
ReportedThe upper six units: the A, B and C chalks and the marls between and below them. The A, B and C chalks are the main horizontal targets in Wattenberg.[2, 6]
Fort Hays Member
ReportedThe lowest chalk and the only unit with its own formal name. In Wattenberg it rests on the Codell or the lower Carlile across an unconformity.[2]
Uncertainties
What is uncertain
Open questionIts layer-bound faults were long read as listric faults. Sonnenberg and Underwood reinterpret them as a polygonal fault system formed as the shale compacted and expelled fluid, which explains their random strikes.[8]