Overview
| Age | Frasnian to Tournaisian, 382.31 to 346.7 million years ago[1, 2] |
|---|---|
| Rank | Formation[2] |
| Other names | Commonly called the Chattanooga Shale in the Salina Basin of Kansas.[2] |
| Thickness | Up to 375 ft (115 m), averaging 40 ft (12 m) across the province; thickest in the south of the basin in Oklahoma, where it fills eroded Hunton channels.[2] |
| Where | Across most of the Anadarko Basin, eroded from the Nemaha, Wichita Mountain and Amarillo uplifts. It also runs into the Salina Basin of Kansas, where it is often called the Chattanooga Shale, and into the Arkoma Basin.[2] |
Entry coverage
13 of 20 topics
Not yet sourced
Type or reference section, Grain size, sorting and sedimentary structures, Sequence stratigraphic setting, Fossils and dating, Diagenesis, Seal quality, Log response and published petrophysics. These are added only when a public source supports them. How the Atlas is made
Rocks and composition
Lithology
ReportedUpper, middle and lower informal members of carbonaceous, silica-rich fissile and non-fissile shale, with phosphatic and siliceous shale, dolomite beds, phosphate nodules and rare chert beds.[2]
How it was laid down
Depositional environment
Published interpretation- Deep, quiet sea. Far from land and below the waves, only fine mud and plankton settle. If the bottom water has little oxygen, organic matter is preserved.[2]
Facies
Published interpretationFissile shale is rich in organic carbon and siliceous shale poor in it. In interbedded shale and chert, the chert holds less organic carbon but more bitumen and oil, suggesting the shale expelled oil well and the chert trapped it.[2]
Boundaries and logs
Boundaries
ReportedLies unconformably on the Silurian to Devonian Hunton Group, filling channels eroded into it after the area had been raised and eroded.[2]
Petroleum significance
- Source rock
- Reservoir
Reservoir quality
ReportedBrittle and silica-rich, so it takes induced fractures. Natural fractures, some filled with bitumen, are most common where late Paleozoic mountain building was strongest.[2, 4]
Source rock potential
ReportedMostly Type II kerogen with some Type III and Type I. Organic carbon averages 3.7 weight percent across 123 wells, highest in the middle member; nearly all of the mature area holds more than 2%. Oil generation began about 330 million years ago in the deep basin, and the shale was mature for oil there by the end of the Permian.[2]
Members and notes
Upper member
ReportedMostly laminated silt-rich mudstone with lag deposits, grading basinward into finer laminated mudstone and then radiolarian chert. Read as the down-slope end of a shallow marine carbonate or mixed system.[2]
Misener sand
ReportedAn informal lower sandy unit, mainly in the north-east of the basin, produced with the Hunton Group as a conventional reservoir.[2]
Worth knowing
Published interpretationOf the same age as the Late Devonian gas shales of the eastern United States, such as the New Albany, Antrim and Ohio shales.[3]
Uncertainties
What is uncertain
Open questionWater depth is uncertain: estimates run from less than 500 ft (150 m) to 160 to 1,300 ft (50 to 400 m). Its vitrinite reflectance may also be suppressed, so true maturity may be higher than measured.[2]