Learn
Petroleum geology, the basics
What rocks are made of, how they were laid down, and why oil ends up where it does. Written for people who work with wells but did not study geology.
Rock types
Almost every oil and gas field is in sedimentary rock: rock made from grains, shells or minerals laid down in layers. These are the ones you meet in North Sea wells[1]. Each one is shown with its standard pattern from geological columns and logs[2].
Sandstone
- What it is
- Sand grains, mostly quartz, stuck together by natural cement. The spaces between the grains can hold oil, gas or water.
- How it forms
- Rivers, beaches, shallow seas and underwater sand flows (turbidites) carry and drop sand. Burial and cement turn it into rock.
- Its job in a field
- The main reservoir rock of the North Sea. Clean, well sorted sand with little cement stores and flows the most.
- On logs
- Usually low gamma ray, because clean quartz sand holds few radioactive minerals. Feldspar and mica raise the reading.
North Sea examples: Skagerrak Formation, Pentland Formation, Fulmar Formation, Burns Sandstone Member
Mudstone and shale
- What it is
- Clay and silt, the finest particles, pressed into rock. Shale is mudstone that splits into thin sheets.
- How it forms
- Mud settles where water is quiet: deep sea, lakes, lagoons, and between floods on river plains.
- Its job in a field
- Tiny pores, so fluids barely move. Mudstone seals oil in. Dark mudstone rich in plant and plankton remains is the source of oil.
- On logs
- Usually high gamma ray (clay holds potassium and thorium). Organic-rich source mudstone reads higher still, as a "hot" shale.
North Sea examples: Smith Bank Formation, Skagerrak Formation, Pentland Formation, Heather Formation
Organic-rich mudstone (source rock)
- What it is
- Dark mudstone with a lot of preserved organic matter, mostly from plankton.
- How it forms
- Laid down where the sea floor had little oxygen, so organic matter was not eaten or rotted away.
- Its job in a field
- Buried deep enough and heated over millions of years, its organic matter turns into oil and then gas. This is the source rock.
- On logs
- Very high gamma ray from uranium bound to the organic matter, and low velocity on the sonic log.
North Sea examples: Burns Sandstone Member, Kimmeridge Clay Formation, Magnus Sandstone Member, Mandal Formation
Chalk
- What it is
- A soft, white limestone made almost entirely of the tiny shells of floating algae (coccoliths).
- How it forms
- Shells rain down on a warm, deep, clear sea floor far from rivers, building metres of ooze over millions of years.
- Its job in a field
- Very porous but tight, so flow needs fractures or reworked, slumped beds. A reservoir in Norwegian fields such as Ekofisk.
- On logs
- Low gamma ray and high velocity. Clay-rich (marly) bands read higher gamma.
North Sea examples: Chalk Group, Ekofisk Formation, Tor Formation, Hod Formation
Limestone and marl
- What it is
- Rock made of calcium carbonate, from shells, reefs or chemical precipitation. Marl is limestone mixed with clay.
- How it forms
- Warm, shallow or open seas with little sand or mud arriving.
- Its job in a field
- Can be a reservoir where fractured or porous; thin hard beds show up as spikes on logs.
- On logs
- Low gamma ray, high velocity and high resistivity. Thin beds show as sharp spikes.
North Sea examples: Zechstein Group, Heather Formation, Cromer Knoll Group, Chalk Group
Dolomite
- What it is
- A carbonate rock like limestone, but made of the mineral dolomite (calcium magnesium carbonate).
- How it forms
- Usually limestone that has been changed after burial or near the surface by magnesium-rich water, often near evaporites.
- Its job in a field
- Can be a reservoir when porous or fractured. In the Southern North Sea the Zechstein dolomites are drilled through above the gas, and hold some gas at Hewett.
- On logs
- Low gamma ray, high density and high velocity, like limestone but denser.
North Sea examples: Zechsteinkalk Formation, Plattendolomit Formation, Seven Rivers Formation, San Andres Formation
Salt and evaporites
- What it is
- Rock salt (halite), anhydrite and related minerals left behind when sea water evaporates.
- How it forms
- A shallow, enclosed sea in a hot, dry climate dries out again and again, leaving thick layers.
- Its job in a field
- Salt is weak and flows under load. It rises into domes and walls that bend the layers above into traps. It is also a near-perfect seal.
- On logs
- Halite reads low gamma ray and low density; anhydrite reads high density. Both have very high resistivity.
North Sea examples: Zechstein Group, Silverpit Formation, Plattendolomit Formation, Castile Formation
Tuff (volcanic ash)
- What it is
- Volcanic ash that settled and hardened into rock.
- How it forms
- Large eruptions throw ash into the air; it falls out over the sea and settles as thin layers.
- Its job in a field
- Thin ash layers spread over a huge area at one moment in time, so they make excellent markers for correlating wells.
- On logs
- Tuff-rich mudstone reads lower gamma ray and higher velocity than ordinary mudstone.
North Sea examples: Balder Formation
Crystalline basement
- What it is
- Very old igneous and metamorphic rock, such as gneiss and granite-like charnockite, that lies under the sedimentary layers.
- How it forms
- Crystallised from melt or recrystallised by heat and pressure deep in the crust, then raised and eroded.
- Its job in a field
- Normally not a reservoir: it has no pores between grains. Where open fractures cut it and stay open, oil can fill them.
- On logs
- High velocity and density; gamma ray depends on the minerals. Open fractures show on image logs and as mud losses.
North Sea examples: Lewisian basement
Coal
- What it is
- Compressed plant matter.
- How it forms
- Swamps and wet coastal plains where plants pile up faster than they rot.
- Its job in a field
- A gas source in some basins. In a section, coal beds point to a coastal or delta setting.
- On logs
- Very low density and slow sonic, so coal stands out sharply.
North Sea examples: Pentland Formation, Statfjord Formation, Brent Group, Ness Formation
How rocks are laid down
Geologists call the place where sediment settled its depositional environment. It decides the shape, size and quality of a reservoir, and so how a well should be steered through it.
Rivers and floodplains (fluvial)
River channels drop sand; floods spread mud across the plain beside them. The result is sand bodies in channel shapes, surrounded by mudstone.
As a reservoir: Channel sands can be excellent, but they are narrow and may not connect from well to well.
Examples: Smith Bank Formation, Skagerrak Formation, Leman Sandstone Formation, Clair Group
Alluvial fans and fan deltas
Where steep streams leave high ground, they dump coarse sand and gravel in fan shapes. A fan delta is one that runs straight into a lake or the sea.
As a reservoir: Coarse and often poorly sorted. Quality changes quickly from the head of the fan to its edges.
Examples: Statfjord Formation
Desert dunes (aeolian)
Wind piles sand into dunes in a dry desert. The grains are well sorted and often frosted by blowing.
As a reservoir: Clean dune sand can be an excellent gas reservoir, until deep burial and clay cement reduce it.
Examples: Leman Sandstone Formation
Desert lake (playa) and salt flat
A shallow lake in a desert basin that floods and dries out, leaving red mud and sometimes salt.
As a reservoir: Not a reservoir. Playa muds and salt seal the dune sands next to them.
Examples: Leman Sandstone Formation, Silverpit Formation
Carbonate ramp and shelf
A warm, shallow sea with little sand or mud, where shells, pellets and ooids build limestone and dolomite, deepening to basin muds.
As a reservoir: Shelf grainstones and dolomites can hold oil or gas, especially where fractured or dissolved into caves.
Examples: Zechsteinkalk Formation, Plattendolomit Formation, San Andres Formation, Madison Group
Coastal plain and delta
Where rivers meet the sea: channels, swamps, lagoons and mouth bars. Sand, mud and coal alternate quickly.
As a reservoir: Many thin sands separated by mud and coal. Good layers, but hard to follow sideways.
Examples: Pentland Formation, Statfjord Formation, Brent Group, Ness Formation
Shoreface and shallow sea
The zone from the beach out to where waves stop stirring the bottom. Waves sort the sand well, and burrowing animals mix it.
As a reservoir: Sheet-like sands that run a long way along the old coastline. Often the best and most continuous reservoirs.
Examples: Fulmar Formation, Brent Group, Rannoch Formation, Etive Formation
Deep-sea sand flows (turbidites and submarine fans)
Sand from the shelf slides downslope in fast underwater flows, spreading out as fans and lobes on the deep sea floor, inside thick mud.
As a reservoir: Thick, stacked sands with mudstone around them. Where sands thin out against mud, they form stratigraphic traps.
Examples: Burns Sandstone Member, Kimmeridge Clay Formation, Punt Sandstone Member, Maureen Formation
Muddy sea shelf
The sea floor of a shallow continental shelf, below the reach of everyday waves. Silt and mud settle, and animals burrow through them.
As a reservoir: Mostly a seal. Storms and currents can bring in thin sands.
Examples: Dunlin Group, Cook Formation, Bakken Formation, Cardium Formation
Deep, quiet sea
Far from land and below the waves, only fine mud and plankton settle. If the bottom water has little oxygen, organic matter is preserved.
As a reservoir: Not a conventional reservoir. Seal rock, and source rock when rich in organic matter. With horizontal wells and hydraulic fracturing, organic-rich mud can produce oil itself, as in the Wolfcamp and Bakken.
Examples: Heather Formation, Kimmeridge Clay Formation, Cromer Knoll Group, Lista Formation
Open ocean ooze (pelagic)
Microscopic shells of floating plankton sink and pile up on the sea floor, far from any river.
As a reservoir: Chalk: high porosity but tiny pores, so it needs fractures or reworking to flow.
Examples: Chalk Group, Ekofisk Formation, Tor Formation, Hod Formation
Drying sea (evaporite basin)
An enclosed sea in a desert climate, cut off and refilled many times, leaving salt and anhydrite.
As a reservoir: Not a reservoir. Salt seals, moves and builds traps.
Examples: Zechstein Group, Castile Formation, Seven Rivers Formation, Madison Group
Deep crust (crystalline basement)
Not laid down as sediment. These rocks formed or were transformed deep in the crust, then lifted and worn down at the surface.
As a reservoir: Only where fractures cut the rock and are held open.
Examples: Lewisian basement
Volcanic ash fall
Ash from distant eruptions falls into the sea and settles as thin, even layers.
As a reservoir: Not a reservoir. A time marker across the whole basin.
Examples: Balder Formation
How an oil field works
Geologists call it the petroleum system. A field needs all five parts, in the right order in time.
Step 1
Source rock
Organic-rich mudstone that, when heated by burial, makes oil and gas. In the Central North Sea this is mainly the Kimmeridge Clay Formation.
Step 2
Migration
Oil and gas are lighter than water, so they move up through porous rock and faults, away from the source.
Step 3
Reservoir
Porous, permeable rock, usually sandstone, where oil and gas collect in the spaces between grains.
Step 4
Seal
A tight rock above the reservoir, usually mudstone or salt, that stops the oil and gas rising further.
Step 5
Trap
The shape that holds everything in place. Structural traps are domes, folds or fault blocks; stratigraphic traps are sands that thin out and pinch out into mud.
The Central North Sea example
- Source. The organic-rich Kimmeridge Clay Formation[3]. It began making oil in the Late Cretaceous to early Paleocene in the deepest grabens[4].
- Reservoirs. Sands of many ages: Triassic rivers at Culzean, Jurassic shoreface at Elgin-Franklin, Jurassic deep-sea sands at Buzzard, Paleocene fans at Forties.
- Seal. Mudstone wrapped around the sands. At Buzzard, the source rock itself encases the reservoir[5].
- Traps. Domes, tilted fault blocks, and sands that pinch out into mud. Moving Zechstein salt shaped many of the structures[6].
Sources
Written in our own words from these sources. Checked 17 November 2026.
- 1Hallsworth and Knox (1999), BGS Rock Classification Scheme, Volume 3: classification of sediments and sedimentary rocks. British Geological Survey, Research Report RR 99-03.
- 2FGDC Digital Cartographic Standard for Geologic Map Symbolization (FGDC-STD-013-2006), section 37: lithologic patterns. U.S. Geological Survey Techniques and Methods 11-A2.
- 3Kimmeridge Clay Formation, BGS Lexicon of Named Rock Units (code KC). British Geological Survey.
- 4Baird (1986), Maturation and source rock evaluation of Kimmeridge Clay, Norwegian North Sea. AAPG Bulletin 70.
- 5Taylor, Webb, Stevenson, Henderson, Kovac, Millington and Rhodes (2020), The Buzzard Field, Blocks 19/5a, 19/10a, 20/1 and 20/6a, UK North Sea. Geological Society, London, Memoirs 52, 691 to 704.
- 6Smith Bank Formation, BGS Lexicon of Named Rock Units (code SMBA). British Geological Survey.