Formation · Cretaceous

Tor Formation

Clean, soft, fractured chalk from the last age of the Cretaceous: the main reservoir of Ekofisk, Valhall, Eldfisk, Hod and Tor.

  • Reservoir

Overview

AgeMaastrichtian, 72.2 to 66 million years ago[1, 2]
RankFormation, part of the Chalk Group[2]
Type sectionNorwegian well 1/3-1, 3,354 to 3,827.5 m below kelly bushing (no cores). Reference sections in UK wells 16/17-6, 22/1-2A, 29/4a-1A and 29/25-1, Danish well Mona-1 and Norwegian well 2/5-1, the Tor Field discovery well.[2]
ThicknessFrom 0 to 472 m in the study wells of the Norwegian sector; in the UK sector over 250 m in the deeps and under 150 m on the highs.[2]
WhereCentral Graben and surrounding areas, Norwegian and UK sectors. Named after the Tor Field.[2]

Entry coverage

11 of 20 topics

Not yet sourced

Other names, Facies, Sequence stratigraphic setting, Fossils and dating, Diagenesis, Reservoir quality, Source rock potential, Seal quality, Uncertainties. These are added only when a public source supports them. How the Atlas is made

Rocks and composition

Lithology

Reported

Very clean chalk, with less than 5% insoluble material, mixing pelagic plankton ooze with chalk that slid or flowed in from nearby highs. Reworked material increases upwards.[2]

Mineralogy

Reported

Very clean chalk, usually under 5 percent insoluble material, light in colour. Pressure solution shows as tooth-shaped (dental) stylolites, typical of pure chalk; dirtier chalks show horsetail solution seams instead.[2]

Grain size, sorting and structures

Reported

Beds of porous, slumped and chaotically bedded chalk are common. In the UK sector softer argillaceous chalk alternates locally with harder, purer limestone. Facies follow the old sea-floor topography, so a well's position against the basin axis, margins, inversion ridges and salt structures controls what it finds.[2]

How it was laid down

Depositional environment

Published interpretation
  • Open ocean ooze (pelagic). Microscopic shells of floating plankton sink and pile up on the sea floor, far from any river.[2]
  • Deep, quiet sea. Far from land and below the waves, only fine mud and plankton settle. If the bottom water has little oxygen, organic matter is preserved.[2]

Boundaries and logs

Boundaries

Reported

Top: the gamma ray usually starts to rise into the Ekofisk Formation, with a rise in velocity and a fall in resistivity; on the crests of the Hod and Valhall fields the Ekofisk is missing and Paleocene shale rests on Tor chalk. Base: hard to pick on logs; the gamma ray often falls a little entering the Tor, and the velocity change runs opposite ways north and south of the Lindesnes Ridge. In the UK sector the base is an abrupt change down into the pink or red argillaceous chalk at the top of the Mackerel Formation.[2]

Log response

Reported

Low gamma ray. The top is usually picked at the start of the gamma ray increase into the Ekofisk Formation, with a velocity increase at Top Tor.[2]

Petroleum significance

  • Reservoir

Members and notes

Worth knowing

Published interpretation

High porosity but low permeability: natural fractures are what let oil flow at Ekofisk, Valhall and Hod.[3, 4, 5]

Worth knowing

Published interpretation

Where the formation sits relative to basin axis, margins, inversion ridges and salt structures controls its facies, so well position matters.[2]

Fields that drill it

Neighbours in the column

Where it sits in geological time.

Neighbours follow the Atlas column. Members sit inside their parent unit, and some units are missing in parts of a basin.

GeoEngine Field Intelligence

This page, inside your geosteering project

Field Intelligence in GeoEngine writes a cited report on the field your well is in: the formations, how they read on logs, where wells do best and what can go wrong. Next, those reports will start from the Atlas entry for your field.

See Field Intelligence